Touch Screen Display - Yaesu FT2DR Operating Instructions Manual


DATA terminal*
• To use the clone function, connect to another
FT2DR/DE with an optional clone cable (CT-
168).
• When updating the firmware, connect to your
PC using a USB cable.
* For instruction to update the firmware, access
our website.
• Connect the optional
microphone (MH-85A11U) to this terminal.
• Connect an external GPS to this terminal.
 MIC/SP jack*
Connect a speaker microphone or earpiece
microphone to this jack.
The waterproof protection cannot be attained
when an external microphone is connected.
Do not connect any microphone which is
not specified by Yaesu. A failure can result.

Touch Screen Display

⑦ ⑧ ⑨ ⑩
④
①
⑤
⑥
④
⑩
②
⑤
⑥
③
① This is the A-band display area.
② This is the B-band display area.
③ Displays touch keys.
④ Displays mode.
In VFO mode, "VFO" is displayed.
In Memory mode, "MR" and the channel
number are displayed.
⑤ Display Bar indicates the volume level.
⑥ Displays the transmit output icon, the S
meter and the PO meter levels.
S meter: Displays the received signal
strength in 9 steps.
PO meter: Displays the transmit power level
in 4 steps.
H I: High power (5W)
L 3: LOW 3 power (2.5W)
L 2: LOW 2 power (1W)
L 1: LOW 1 power (0.1W*
camera-equipped
*: When the included antenna and battery pack are
⑪ ⑫
⑬
⑭
⑮
⑬
⑭
)
1
Names and Functions of Controls
 EXT DC IN jack*
• When charging the battery pack, connect the
battery charger (PA-48 or SAD-14B) to this jack.
• In the USA/EXP market, connect an external
power supply adapter with a cigarette lighter
plug (SDD-13) or an external power cable (E-
DC-6) to this jack.
Do not connect any battery charger which
is not specified by Yaesu. A failure can
result.
installed and the MIC/SP jack, EXT DC IN jack, DATA
terminal, and micro SD slot are securely covered with
rubber caps, the FT2DR/DE meets the waterproofing
performance conforming to IPX5 (See page 13).
⑦ Displays the time.
⑧ Displays the frequency shift direction during
repeater operation (
-: Minus shift
+: Plus shift
@: Split operation
⑨
lights when the mute function is active
( see page 44).
⑩ Displays the frequency.
⑪ Displays icon types.
: Lights when Auto Power Off is active
( see page 145).
: Lights when DTMF function is
enabled ( see page 103).
: Lights when GPS is acquired (
page 86).
: Lights when GPS Log Function is
enabled ( see page 89).
: Lights when a microSD memory card
is inserted (
⑫ The battery condition is displayed in 8
steps.
: Full battery power
: Battery is depleted. Charge battery.
: (When blinking) Charge battery
immediately.
* : European version (VHF: 0.05W)
1
see page 52).
see
see page 29).
15