Listening to the Radio
Listening to the AM/FM Radio
AM broadcasts (middle wave band) and FM broadcasts can be easily received using
"Preset Memory Receiver" (
already saved to the transceiver memory. You can also tune in to the desired frequency by
rotating the DIAL or directly inputting the frequency from the numeric keypad input screen.
1
Press the
2
Press the
3
Rotate the DIAL or display the numeric keypad input screen to tune in to the desired
frequency (
Tips
• Broadcast stations can be saved to the memory channels (
• To scan a broadcast radio band, set A-band to the operating band and touch [F MW] followed by
[SCAN].
• When a signal is detected while scanning, a beep will sound; the transceiver will receive the signal
for 5 seconds then resume scanning.
• The decimal point will flash when scanning stops.*
*You can change the scan restart time interval.
42
see page 65), where many major broadcast stations are
key to set the A-band as the operating band.
key to select either the "AM broadcast" or "FM broadcast" band.
see page 38).
see page 54).