Setting The Dcs Code; Searching For The Dcs Code Used By The Remote Station - Yaesu FT2DR Operating Instructions Manual

Using the Tone Squelch Function

Setting the DCS Code

The DCS code can be selected from 104 types (from 023 to 754).
1
Press and hold the
The transceiver enters Set mode.
2
Touch [SIGNALING].
3
Touch [2 DCS CODE].
4
Rotate the DIAL to select the desired DCS code.
5
Gently press the
The DCS code is set and the transceiver exits from Set mode.
Tip
The default setting is [023].

Searching for the DCS Code Used by the Remote Station

Search and display the DCS code used by the remote station.
1
Press and hold the
The transceiver enters Set mode.
2
Touch [SIGNALING].
3
Touch [2 DCS CODE].
112
key for over one second.
key 3 times.
key for over one second.