Selecting The Communication Mode - Yaesu FT2DR Operating Instructions Manual

3
Enter the frequency using the numeric keys.
Example: To input 145.520 MHz
[1] → [4] → [5] → [5] → [2]
Example: To input 430.000 MHz
[4] → [3] → [ENT]
Tips
• In factory settings, Auto Step mode is set so that the transceiver is automatically switched to the
optimal frequency steps for the receiver frequency.
The frequency may be changed in 1 MHz steps by touching [F MW] and rotating the DIAL (
page 47).
• If a wrong digit is entered when entering a frequency using the numeric keys, it may be canceled by
pressing .
• In factory settings, turning the DIAL beyond the selected frequency band causes the transceiver to
switch to the next frequency band.
To change the tuning so the frequency will move repeatedly through the selected band, press and
hold for over one second to switch to Set mode, then touch [CONFIG] → [21 VFO MODE] and
select "BAND" to repeatedly show frequencies on the same frequency band.

Selecting the Communication Mode

y Using AMS
This transceiver is equipped with AMS (Automatic Mode Select) which automatically
selects between 4 modes of transmission to correspond to the signal being received.
Because the transmitter is automatically adjusted to that of the other station, C4FM digital
signals and analog signals are both recognized automatically.
To utilize the AMS function, touch [MODE] to display "
the signal, "DN" of "
*The display differs depending on the received signal.
" will be changed according to the received signal.
Performing Communication
"* on the LCD. After receiving
Example of when
AMS is displayed
see
39