Selecting The Vibrator Operation Mode; Notification Of A Call From A Remote Station By The Bell Function - Yaesu FT2DR Operating Instructions Manual

Using the Tone Squelch Function
Tips
• The vibrator can function for all frequency bands belonging to A-band (Main) and B-band (Sub).
• If you select [BUSY] in step 5, when the transceiver receives a signal, BUSY LED and the vibration
function turn on simultaneously regardless of the communication mode or squelch type.
• The vibrator functions when the vibrator setting is other than OFF. Press
and release to deactivate the vibrator for 5 seconds.

Selecting the Vibrator Operation Mode

1
Press and hold the
The transceiver enters Set mode.
2
Touch [CONFIG].
3
Touch [22 VIBRATOR], then press the
4
Rotate the DIAL to select [SELECT], then press the
5
Rotate the DIAL to select the desired vibrator operation.
Remark The default setting: PATTERN1
PATTERN1
PATTERN2
PATTERN3
6
Press .
The selected vibrator operation is set and the transceiver exits from Set mode.
Notification of a Call from a Remote Station by the
Bell Function
Set the Bell sound to alert you of a call from a remote station containing a corresponding
tone or DCS code.
1
Press and hold the
The transceiver enters Set mode.
2
Touch [SIGNALING].
3
Touch [1 BELL].
114
key for over one second.
The vibrator functions continuously.
The vibrator functions at long intervals.
The vibrator functions at short intervals.
on the LCD blinks at the same time.
key for over one second.
to perform transmission,
key.
key.