Muting Audio - Yaesu FT2DR Operating Instructions Manual

Miscellaneous Settings
8
Rotate the DIAL to select the minute, then press the
key.
Tip If GPS information is received, the time will be set
automatically.
9
To activate the time signal (alarm goes off every hour on
the hour), touch [SIGNAL ON].
The checkbox will be checked.
10
Touch [OK].
The transceiver exits from Set mode.
Remark The current time appears on the LCD.
Tips
• At normal temperature, the time deviation is ±30 seconds per month. It may vary depending on the
environment conditions, such as the temperature .
• The transceiver is equipped with a rechargeable lithium battery dedicated for the clock. Normally,
the transceiver is powered from the battery pack. When the battery pack is detached or runs
out, the lithium battery starts operating automatically. The lithium battery can power the clock for
approximately 2 months.
• When you use the transceiver for the first time or without the battery pack for a long period of time,
the accuracy of the clock may be poor. In such case, reattach the battery pack and adjust the time.
• The calendar can display dates from January 1, 2000 A.D. up to December 31, 2099 A.D.
• Press and hold
SET] followed by [AUTO] to display accurate time automatically.
• Using the timer function enables the transceiver to automatically turn off at a specified time (
page 149). In addition, you can set the transceiver to turn on at a specified time (

Muting Audio

If the A-band and B-band are heard simultaneously during dual receive, and it is difficult
to hear the voices, the audio of the non-operating band may be muted.
1
Press and hold the
The transceiver enters Set mode.
2
Touch [TX/RX].
44
for over one second to enter Set mode, then select [APRS] → [21 GPS TIME
key for over one second.
see
see page 149).