Selecting a Receive Operation When Scanning Stops
Touch [4 SCAN RESUME] to set the receive operation for when scanning stops.
For details, see "Setting the Receive Operation When Scanning Stops" on page 74.
Setting the Scanning Range
You can set the frequency range for scanning in VFO mode and Memory mode.
1
Touch [5 SCAN WIDTH].
2
Rotate the DIAL to select [VFO], then press the
3
Rotate the DIAL to select the desired setting referring to the table below.
Scans all bands from the current frequency within the 1.8 MHz to 999
ALL
MHz range.
BAND
Starting with the current frequency, scans within the current band.
4
Press the
key.
5
Rotate the DIAL to select [MEMORY], then press the
6
Rotate the DIAL to select the desired setting referring to the table below.
Scans all memory channels (1 to 900) starting with the currently specified
ALL CH
memory channel. When "Selected memory channel" is selected, all
specified memory channels are scanned (
Scans only the memory channels to which the frequencies are registered,
within the same frequency band
channel.
BAND
When the memory channels are registered as the specified memory
channels, scans only the specified memory channels to which the
frequencies are registered, within the same frequency band.
*1: For the relationship between frequency bands and receive frequencies, see the table at the
bottom of page 36.
Set Mode: SCAN Menu Operations
key.
key.
see page 76).
as the currently specified memory
*1
*1
143