Set (Menu) Mode - Yaesu FT-25R Advance Manual

Set (Menu) Mode

Many FT-25R/E functions have already been described in previous chapters,
The Set Mode Menu is used to configure the transceiver parameters, some of
which have not been detailed previously. Use the following procedure to activate
the Set Mode and configure the FT-25R/E function parameters:
1. Press and hold the F key to enter the Set Mode.
2. Press the [▲] or [▼] key to select the Set Mode Item to be adjusted.
3. Press the F key momentarily to enable adjustment of the Set Mode Item.
4. Press the [▲] or [▼] key to adjust or select the parameter to be changed on the se-
lected Set Mode Item.
5. After completing the selection and adjustment, press the PTT switch momentarily to
save the new setting and exit to normal operation.
Press and hold the F key to move from the lower menu contents to the upper
menu in the Set Mode.
Item
(lower menu
item)
1 APO Setting of the Automatic Power-Off
feature.
2 ARTS Selects the Beep option and
the Polling Interval during ARTS
operation.
3 BATTSAVE Selects the Receive-mode Battery
Saver interval ("sleep" ratio).
4 B-CH.L/O Enables/disables the Busy Channel
Lock-Out feature.
5 BEEP Beep function Enable/Disable on
pressing the keypad, or stopping
the receiver scanning.
KEY+SC : The beeper sounds
KEY : The beeper sounds when
OFF : Beeper is disabled.
6 BELL Select the number of CTCSS/
DCS/PAGER/ARTS Bell ringer
repetitions.
7 COMPANDE Enables/disables the Voice
(COMPANDER) Compander feature.
8 CTCSS Setting the CTCSS Frequency TX
(CTCSS TONE) and RX.
CW Identifier during ARTS
9 CW ID
operation.
10 DC VOLT displays Battery DC Voltage.
11 DCS CODE Setting the DCS CODE TX and RX. 104 DCS CODEs / OFF
FT-25R/FT-25E Advance Manual 36
Function
when any key is
pressed, or when the
scanner stops.
any key is pressed.
Values
OFF / 0.5H to 12.0H (Step
0.5H)
BEEP= INRANG / ALWAYS /
OFF
INTV= 25SEC / 15SEC
200mS / 300mS / 500mS /
1SEC / 2SEC / OFF
OFF / ON
KEY+SC / KEY / OFF
OFF / 1Time / 3Times/
5Times / 8Times /
CONTINUE
OFF / ON
50 CTCSS tones / OFF
TX= OFF / ON
ID= ------ (6 characters)
−
Default Value
OFF
32
BEEP=OFF
INTV= 25SEC 25
200mS
−
OFF
33
KEY+SC
−
OFF
11
OFF
33
TX=100.0Hz
10
RX=100.0Hz
TX= OFF
27
ID= blank
−
6
TX=023
11
RX=023