Recalling Preset Receiver Memory Channel To Listen To The International Vhf (Marine) Radio - Yaesu FT2DR Operating Instructions Manual

Hide thumbs Also See for FT2DR:
Table of Contents

Advertisement

Recalling Preset Receiver Memory Channel to Listen to the
International VHF (Marine) Radio
The frequencies (57 channels) used for the international VHF marine radio are registered
in the dedicated preset receiver memory channels.
1
Press the
key to set the A-band as the operating band.
2
Touch [F MW].
3
Touch [P.RCVR].
Preset Receiver mode is activated.
4
Press the
key to select [INTVHF].
5
Rotate the DIAL to select the desired channel.
Remarks
• For the available international VHF channels, see the following table.
• To stop reception of the international VHF radio, touch [F MW] followed by [P.RCVR]].
In the event of extreme weather disturbances, such as storms and hurricanes, the NOAA (National Oceanic
and Atmospheric Administration) sends a weather alert accompanied by a 1050 Hz tone and subsequent
weather report on one of the NOAA weather channels. You may enable the Weather Alert tone via Set Mode
option [SIGNALING] → [14 WX ALERT], if desired (See page 124).
Tips
• The preset receiver memory channel cannot be rewritten with another frequency or data.
• To scan the preset receiver memory channels toward higher channel numbers, touch [F MW]
followed by [SCAN]. To scan the preset receiver memory channels toward lower channel numbers,
rotate the DIAL counterclockwise until it clicks once during scanning. When a signal is received
during scanning, the scanning stops to receive the frequency for 5 seconds.
• To set the transceiver operation when scanning stops, see "Setting the Receiver Operation"Setting
the Receive Operation When Scanning Stops" on page 74.
• To register the International VHF Marine channels into a memory bank, follow the procedure in
"Registering Preset Receiver Memory Channels into Memory Banks" on page 66.
Frequencies of International VHF Marine radio frequencies
registered in the preset receiver memory channels
Memory channel No.
1
2
3
4
5
6
7
8
9
10
11
12
Convenient Preset Receiver Memory Channels
Frequency (MHz)
156.050
160.650*
156.100
160.700*
156.150
160.750*
156.200
160.800*
156.250
160.850*
156.300
156.350
160.950*
156.400
156.450
156.500
156.550
156.600
Memory channel No.
60
61
62
63
64
65
66
67
68
69
70
71
Frequency (MHz)
156.025
160.625*
156.075
160.675*
156.125
160.725*
156.175
160.775*
156.225
160.825*
156.275
160.875*
156.325
160.925*
156.375
156.425
156.475
156.525
156.575
67

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft2deFt2drde

Table of Contents