Pci Fan Assembly; Removing The Pci Fan Assembly - Sun Microsystems Ultra 60 Service Manual

8.2

PCI Fan Assembly

To remove and replace the PCI fan assembly, proceed as follows.
8.2.1

Removing the PCI Fan Assembly

1. Power off the system unit.
See Section 6.2, "Powering Off the System Unit" on page 6-3.
2. Remove the side access cover.
See Section 7.1, "Removing the Side Access Cover" on page 7-2.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Attach the wrist strap.
See Section 7.2, "Attaching the Wrist Strap" on page 7-3.
4. Disconnect the PCI fan assembly as follows (
a. Remove any long PCI cards.
See Section 10.3.1, "Removing a PCI Card" on page 10-7.
b. Disconnect the PCI fan power harness from the motherboard.
c. Press the locking snap and disengage.
d. Disengage the studs from the chassis slot.
5. Remove the PCI fan assembly by moving it back, over, and up.
):
FIGURE 8-3
Chapter 8 Major Subassemblies 8-5