Sun Microsystems Ultra 60 Service Manual page 106

4. Remove the SCSI drive bay as follows (
a. Remove the hard drive(s).
See Section 9.1.1, "Removing a Hard Drive" on page 9-2.
b. Disconnect the SCSI cables from the motherboard connectors.
c. Disconnect the peripheral power cable.
d. Remove the peripheral power cable from the cable routing clips.
e. Remove the diskette drive cable from the plastic spring clips installed adjacent
to the drive bay.
f. Unfeed the peripheral power cable through the chassis opening.
g. Using a number 2 Phillips-head screwdriver, remove the screws securing the
SCSI drive bay to the chassis.
h. Feed the SCSI cable under the PCI fan bracket while pulling up in Step g.
i. Slide the SCSI drive bay out of the chassis.
8-8 Sun Ultra 60 Service Manual • August 2001
):
FIGURE 8-4