Mitsubishi QJ71C24/-R2 User Manual page 193

8 UTILITY PACKAGE (GX Configurator-SC)
8 - 14
File save
File read
Close
End setup
POINT
(1) When the setting operation is complete in each system setting screen, register
the system setting data in the flash ROM, then restart the PLC CPU to resume
data transmission.
(2) If two or more intelligent function module utility package are running, perform
each operation after selecting the target utility package from the task bar and
making it active.
(3) When the menu screen for system registration to flash ROM (see Section 8.4) is
closed, all the system setting data will be cleared. Before closing the screen, write
the data to the module (enabled only via online operation) or save it to a file.
(3) Data/file to be created with utility package
The data and files shown below that are created with utility package are also
used by GX Developer operation. Figure 8.1 shows an operation used to create
data with utility package.
<Intelligent function module parameters>
(a) This data is created with the auto refresh settings, and stored in the intelligent
function module parameter file of the project to be created using GX Developer.
Project
Program
Parameters
(b) Steps 1) to 3) shown in Figure 8.1 are performed using the following operations.
1) Operating from GX Developer.
[Project]
2) Operating from the utility parameter setting module selection screen.
[File]
3) Operating from the GX Developer.
[Online]
module parameters"
Or, operate from the utility parameter setting module selection screen.
[Online]
: Saves all system setting data for the Q series C24
to the designated file (extension: UMD).
: Reads all system setting data for the Q series C24
from the designated file (extension: UMD).
: Closes the currently displayed screen and returns
to the previously displayed screen.
: Saves/writes the system setting data, closes the
current screen, and returns to the previously
displayed screen.
With offline operation, only [File save] and [File
read] are enabled.
PLC Parameters
Network Parameters
Intelligent Function Module Parameters
[Open existing project] / [Save project] / [Save project as]
[File read] / [File save]
[Read from PLC / [Write to PLC]
[Read from PLC] / [Write to PLC]
MELSEC-Q
"Intelligent function
8 - 14