Switching Backgrounds Using Dme Wipes; Setting User Regions; Setting The Side Flag Video Material And Operation - Sony MVS-3000 System User Manual

1
In the Engineering Setup >Switcher >Config menu
(7331), press [PGM Config].
The PGM Config menu (7331.2) appears.
The status area shows the background and key
configuration assigned to the output of each bank.
2
Select the output you want to set.
3
In the <Bkgd> group, select the background.
In Multi Program mode, select [Clean] or [Utility1],
then skip to step 4.
4
In the <Key Enable> group, select [Enable] or
[Disable] for each of the keys.
Setting the key preview configuration
You can make this setting at any time, regardless of the
operation mode.
1
In the Engineering Setup >Switcher >Config menu
(7331), press [K-PVW Config].
The K-PVW Config menu (7331.3) appears.
The status area shows the key preview configuration
for each bank.
2
Select the key preview to set.
3
In the <Mode> group, select [Video] mode or [Key]
mode.
If you select Key mode, skip to step 5.
4
In the <Bkgd> group, select the background.
In standard mode or Multi Program mode, select
[Clean] or [Utility1], then skip to step 5.
5
In the <Key1> to <Key8> groups, select the
corresponding key status from the following.
Link: Follows the key on/off setting.
On: Key is always on.
Off: Key is always off.
Switching Backgrounds using DME
Wipes
Notes
• Only the background DME wipe or key 1 can be enabled
at any one time.
• If background DME wipe is enabled, side flags cannot
be used in DME wipes.
This setting can be made for each of the M/E and PGM/
PST banks.
1
In the Engineering Setup >Switcher >Config menu
(7331), select the target M/E or P/P bank.
2
In the <BKGD DME Wipe/Key1> group, select
[BKGD DME Wipe].

Setting User Regions

This assigns the color backgrounds 1 and 2, AUX1 to 24,
and frame memory 1 to 8 for User regions to any of User1
to User8.
Notes
If you change the user region settings, the previously
stored snapshot data and keyframe effect data can no
longer be used.
1
In the Engineering Setup >Switcher >Config menu
(7331), press [User1-8 Config].
The User1-8 Config menu (7331.4) appears.
The status area shows the region names and assigned
user region numbers.
2
Select the region to set.
3
In the <User Region Assign> group, select the user
region you want to assign. If you do not want to assign
a user region, select [No Assign].
4
Repeat steps 2 and 3 as required to make the settings
for other regions.
5
Press [Execute].
6
Check the message, then press [Yes].
Setting the Side Flag Video Material
and Operation
Makes settings relating to the video material (4:3 aspect
ratio) for applying side flags
(p. 128)).
Setting the aspect ratio (4:3/16:9)
1
In the Engineering Setup >Switcher >Config menu
(7331), press [Side Flags].
The Side Flags menu (7331.7) appears.
The status area lists the video/key pair numbers, video
(1 "Side Flag Settings"
Settings for Switcher Configuration
241