Editing The Dme Wipe Pattern - Sony MVS-3000 System User Manual

Note, however, that the pattern numbers for DME wipe
patterns have four digits

Editing the DME Wipe Pattern

By pressing the [EDIT ENBL] button to switch the
memory recall section to editing mode, you can edit the
selected DME wipe pattern.
To exit from the editing mode, press the [EDIT ENBL]
button again, or press the [EXIT] button.
The operation of the following buttons is the same as when
editing a wipe pattern.
• [EXIT] button
• [PTN LIMT], [LIMT SET] buttons
• [NORM], [NORM/REV], [REV] buttons
• [KNOB 1/2] button
For details about each button operation,
Wipe Pattern" (p. 91).
DME wipe pattern edge setting buttons
BDR (border): Applies a border to the DME wipe pattern.
SOFT BDR (soft border): Softens the applied border.
You can adjust the parameters selected with these buttons
using the adjustment knobs, when the button is lit green.
When border is selected
No. Parameter
1 W
2 L
3 S
4 H
When soft border is selected
Parameter group [1/2]
No. Parameter
1 W
2 I
100
DME Wipe Pattern Operations in the Flexi Pad
p. 264).
(1
1 "Editing the
Adjustment
Border width
Luminance
Saturation
Hue
Adjustment
Border width
Border inner softness
Parameter group [2/2]
No. Parameter Adjustment
1 L Luminance
2 S Saturation
3 H Hue
Buttons for positioning the DME wipe
pattern
POS (positioner): Adjusts the position of the DME wipe
pattern.
CNTR (center): Returns the DME wipe pattern position
to the center.
When you press the [POS] button, the alphanumeric
display first shows the name of the parameter, "H" or "V,"
and then the value of the parameter.
When the [POS] button is lit green, you can adjust the
position of the pattern with the adjustment knobs.
No. Parameter Adjustment
1 H Horizontal position
2 V Vertical position
3 H (R) Relative movement in the horizontal
direction
4 V (R) Relative movement in the vertical
direction
Buttons for setting DME wipe pattern
cropping
CROP: Adjusts the DME wipe pattern cropping.
4:3 CROP: Crops a 16:9 image to 4:3.
When the [CROP] button is lit green, you can set the
cropping ratio of the DME wipe pattern with the
adjustment knobs.
Parameter group [1/2]
No. Parameter Adjustment
1 H Crop the left and right of the image
2 V Crop the top and bottom of the image
3 A Crop the left, right, top, and bottom of
the image
Parameter group [2/2]
No. Parameter Adjustment
1 T Crop the top of the image
2 L Crop the left of the image
3 R Crop the right of the image
4 B Crop the bottom of the image
Button for specifying effect size
SIZE: Specifies the effect size.