Making The Serial Tally Source Address Settings - Sony MVS-3000 System User Manual

(The display relating to DCU is disabled, even if
selected.)
2
In the <Tally Group> group, select the tally group.
3
In the <Tally Type> group, press the tally types to
select. (You can select up to four.)
Notes
The selectable tally types depend on the settings in
step 2.
4
In the <Tally Data Size> group, press one of the
following to select the data size.
128 Bit: 128 bits
256 Bit: 256 bits
Making the Serial Tally Source
Address Settings
To set the serial tally source address for each port, use the
following procedure.
1
Open the Engineering Setup >Router/Tally >Serial
Tally >Source Assign menu (7367.1).
2
In the<Serial Tally Port> group, select the port to
which the setting applies.
3
Select the bit number of the port.
4
Select the source address.
No. Parameter
2 Source Addr Source address selection
5
Press [Source Address Set].
Clearing a source address setting
To clear a source address setting for a particular
bit
In the Source Assign menu, select the serial tally port and
bit number (see steps 2 and 3 in the previous item), then
press [Clear].
To clear all source address settings
In the Source Assign menu, select the serial tally port, then
press [All Clear].
Check the message, then press [Yes].
260
Serial Tally Settings
Adjustment