Sony MVS-3000 System User Manual page 304

Icon Message
Clip register error (–14).
Can't extract pair clip (–15).
Clip id not enough (–50).
Still frame on FM 2nd board (–51).
Clip frame number can't be ODD in
720P format (–9).
File Frame Memory
Some requests are skipped.
Following operation is not permitted.
— Loading that will cause duplicate
register name.
File Open Status
ERROR (01)
ERROR (02)
ERROR (FF): No target device has
been assigned
GPI Input
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
GPI Output
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Pulse Width.
Please set Pulse Timing.
HDD Format
No external HDD was found (–2).
Format operation failed (–11).
Cannot access the partition (–12).
304
Error Messages
Description
2542: Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is pressed, this message
appears if the specified register number data cannot be processed (internal
processing error).
2542: Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is pressed, this message
appears if an attempt is made to extract a pair clip.
2542: Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is pressed, this message
appears if there are 100 clips or more.
2542: Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is pressed, this message
appears if a still image was extracted from an external clip.
2542: Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is pressed, this message
appears if an odd number of clips are extracted (720P format only).
7151: File >Frame Memory
7162: File >All, External File >Import/Export
In the above menus, an attempt was made to load a file of a name already
existing in the register.
533X: Device >DDR/VTR
When an error is returned from the DDR/VTR, one of these messages
appears, depending on the error number.
Use the following menus to check the device settings.
7325.4: Engineering Setup >Panel >Device Interface >Device Assign
7325.5: Engineering Setup >Panel >Device Interface >Serial Port Assign
7325.1/2: Engineering Setup >Panel >Device Interface >GPI Input
7357.2/3: Engineering Setup >Switcher >Device Interface >GPI Input
In the above menus, when making a setting, a parameter setting value was
incorrect. Check the settings, and try again.
7325.3: Engineering Setup >Panel >Device Interface >GPI Output
7337.4: Engineering Setup >Switcher >Device Interface >GPI Output
In the above menus, when making a setting, a parameter setting value was
incorrect. Check the settings, and try again.
2561: Frame Memory >External Device >Ext HDD Format
In the above menu, when [5 Partition] or [15 Partition] is pressed, this
message appears if the external HDD cannot be found. Check that the
external HDD is correctly connected.
2561: Frame Memory >External Device >Ext HDD Format
In the above menu, when [5 Partition] or [15 Partition] is pressed, this
message appears if HDD formatting failed.
2561: Frame Memory >External Device >Ext HDD Format
In the above menu, when [5 Partition] or [15 Partition] is pressed, this
message appears if the external HDD logical drive could not be accessed.
Check that the external HDD is correctly formatted.