Reset And Initialization; Installation And Device Setup; Installing Software - Sony MVS-3000 System User Manual

Reset and Initialization

You can carry out a reset or memory initialization for a
device.
• Reset: Resets state after powering on.
• All Clear: Clears the memory and restores the factory
default settings. The Network Config, Format, and Start
Up setup values are set by reference to data stored in
non-volatile memory, and the system automatically
starts up. It is not necessary to reset the Date/Time
settings.
For details, 1 "Saving and Recalling Setup Data"
(p. 214).
Notes
Resetting SWR1 also resets PNL1 at the same time.
However, resetting PNL1 does not reset SWR1.
1
In the status area of the Engineering Setup >System
>Initialize menu (7315), select the device.
2
In the <Initialize> group, select one of the following
modes.
Reset: Resets the target device, causing it to restart in
the start-up state.
All Clear: Initializes the target device, causing it to
restart in the factory default state.
3
Press [Execute].
4
Check the message, then press [Yes].
Installation and Device
Setup
This installs the software and firmware in all devices
connected to the LAN.
Displaying installation details
In the Engineering Setup >System >Install/Unit Config
menu (7316), press [Detail Information].
This accesses the Detail Information menu (7316.1), and
displays the detailed information on the software and
firmware installed in the currently selected device.

Installing Software

1
Insert the removable disk containing the software to
the USB connector of the external monitor or control
panel.
2
In the Engineering Setup >System >Install/Unit
Config menu (7316), press [Install].
The Install menu (7316.10) appears; the status area
shows the following information.
Upper list: For each connected device, this shows the
device name, current software version (Current),
and the latest version that can be installed (Install,
Title).
• OK: Installation already completed.
• On: For installation, but not completed.
• Error: An error occurred during installation.
• Cancel: Installation canceled.
Lower list: For the device selected in the upper list,
this shows an automatically detected list of
software that can be installed on the particular
device. Also, software selected as a candidate for
installation in the upper list is marked in the lower
list with a bullet.
3
If you are satisfied with the currently installed version
of all items in the upper list, skip to step 6.
To change the items to be installed, select the relevant
device.
To display all related software
Press [Display All Software], turning it on.
Not just the automatically detected software, but the
names of all related software for the selected device
appear.
4
In the lower list, select the software you want to install.
5
Press [Set].
The selection is reflected under "Install" and "Title" in
the upper list.
6
Press [Install].
The "Install" box shows "On," confirming that this is
to be installed. To cancel this installation setting, press
"Install" once more, making the box blank.
7
Repeat steps 3 to 6, to confirm all software to be
installed.
8
Press [Execute].
9
Check the message, then press [Yes].
Reset and Initialization / Installation and Device Setup
215