Global Dhcp Relay Configuration Example - ZyXEL Communications GS2210 Series User Manual

Table 171 IP Application > DHCP > DHCPv4 > Global > Port (continued)
LABEL
Add
Cancel
Clear
Index
Port
Profile Name
Delete
Cancel

40.4.5 Global DHCP Relay Configuration Example

The follow figure shows a network example where the Switch is used to relay DHCP requests for the
VLAN1 and VLAN2 domains. There is only one DHCP server that services the DHCP clients in both
domains.
Figure 239 Global DHCP Relay Network Example
DHCP Server:
192.168.1.100
Configure the DHCP Relay screen as shown. Make sure you select a DHCP option 82 profile
(default1 in this example) to set the Switch to send additional information (such as the VLAN ID)
together with the DHCP requests to the DHCP server. This allows the DHCP server to assign the
appropriate IP address according to the VLAN ID.
Chapter 40 DHCP
DESCRIPTION
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Click Clear to reset the fields to the factory defaults.
This field displays a sequential number for each entry. Click an index number to change the
settings.
This field displays the port(s) to which the Switch applies the settings.
This field displays the DHCP option 82 profile that the Switch applies to the port(s).
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select the entry(ies) that you want to remove, then click the Delete button to remove the
selected entry(ies) from the table.
Click this to clear the check boxes above.
VLAN1
GS2210 Series User's Guide
VLAN2
343