ZyXEL Communications GS2210 Series User Manual page 390

Figure 276 Management > Syslog Setup
The following table describes the labels in this screen.
Table 196 Management > Syslog Setup
LABEL DESCRIPTION
Syslog Select Active to turn on syslog (system logging) and then configure the syslog setting
Logging Type This column displays the names of the categories of logs that the device can generate.
Active Select this option to set the device to generate logs for the corresponding category.
Facility The log facility allows you to send logs to different files in the syslog server. Refer to the
documentation of your syslog program for more details.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Syslog Server
Setup
Active Select this check box to have the device send logs to this syslog server. Clear the check
box if you want to create a syslog server entry but not have the device send logs to it
(you can edit the entry later).
Server Address Enter the IP address of the syslog server.
Log Level Select the severity level(s) of the logs that you want the device to send to this syslog
server. The lower the number, the more critical the logs are.
Chapter 46 Syslog Setup
GS2210 Series User's Guide
390