ZyXEL Communications GS2210 Series User Manual page 60

in the Quick Links section of the Status screen to display the Port Status screen as shown next.
You can also click Management > Port Status to see the following screen.
Figure 47 Port Status (for PoE model(s))
The following table describes the labels in this screen.
Table 10 Port Status
LABEL DESCRIPTION
Port This identifies the Ethernet port. Click a port number to display the Port Details screen
(refer to
Name This is the name you assigned to this port in the Basic Setting > Port Setup screen.
Link This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M for
1000Mbps) and the duplex (F for full duplex or H for half). It also shows the cable type
(Copper or Fiber) for the combo ports.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
Section 13.1 on page 121
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
PD For PoE model(s) only.
This field displays whether or not a powered device (PD) is allowed to receive power from
the Switch on this port.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on
the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the number of kilobytes per second transmitted on this port.
Chapter 7 Status and ZON
Figure 48 on page 61).
for more information.
GS2210 Series User's Guide
60