Ipv6 Multicast Status - ZyXEL Communications GS2210 Series User Manual

Table 82 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile (continued)
LABEL
End Address
Add
Clear
Profile Name
Start Address
End Address
Delete Profile
Delete Rule
Delete
Cancel

24.4 IPv6 Multicast Status

Click Advanced Application > Multicast > IPv6 Multicast to display the screen as shown. This
screen shows the IPv6 multicast group information. See
information on multicasting.
Figure 138 Advanced Application > Multicast > IPv6 Multicast
The following table describes the fields in the above screen.
Table 83 Advanced Application > Multicast > IPv6 Multicast
LABEL
Index
VID
Port
Multicast Group
Group Timeout
Chapter 24 Multicast
DESCRIPTION
Type the ending multicast IP address for a range of IP addresses that you want to belong
to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and
End Address fields.
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Clear to reset the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
Select a profile's check box to select a specific profile. Otherwise, select the check box in
the table heading row to select all profiles.
Select the check box(es) of the rule(s) that you want to remove from a profile.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete
Rule column, then click the Delete button.
Click Cancel to clear the Delete Profile/Delete Rule check boxes.
DESCRIPTION
This is the index number of the entry.
This field displays the multicast VLAN ID.
This field displays the port number that belongs to the multicast group.
This field displays IP multicast group addresses.
This field displays the time (in seconds) that elapses before the Switch removes a MLD
group membership entry if it does not receive report messages from the port.
GS2210 Series User's Guide
196
Section 24.1 on page 186 for more