Arp Inspection Vlan Status - ZyXEL Communications GS2210 Series User Manual

Figure 163 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection
The following table describes the labels in this screen.
Table 105 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection
LABEL
Total number of
filters
Index
MAC Address
VID
Port
Expiry (sec)
Reason
Delete
Cancel
Change Pages

26.8 ARP Inspection VLAN Status

Use this screen to look at various statistics about ARP packets in each VLAN. To open this screen,
click Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP
Inspection > VLAN Status.
Chapter 26 IP Source Guard
DESCRIPTION
This field displays the current number of MAC address filters that were created because
the Switch identified unauthorized ARP packets.
This field displays a sequential number for each MAC address filter.
This field displays the source MAC address in the MAC address filter.
This field displays the source VLAN ID in the MAC address filter.
This field displays the source port of the discarded ARP packet.
This field displays how long (in seconds) the MAC address filter remains in the Switch.
You can also delete the record manually (Delete).
This field displays the reason the ARP packet was discarded.
MAC+VLAN: The MAC address and VLAN ID were not in the binding table.
IP: The MAC address and VLAN ID were in the binding table, but the IP address was
not valid.
Port: The MAC address, VLAN ID, and IP address were in the binding table, but the port
number was not valid.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Check the entry(ies) that you want to remove and then click Delete to remove the
selected entry(ies) from the summary table.
Click Cancel to clear the check boxes.
Click Previous Page or Next Page to show the previous/next screen if all status
information cannot be seen in one screen.
GS2210 Series User's Guide
237