Mld Snooping-Proxy Vlan Port Role Setting - ZyXEL Communications GS2210 Series User Manual

Table 85 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN
LABEL
Last Member Query
Interval
Downstream
Query Interval
Maximum Response
Delay
Add
Cancel
Clear
Index
VID
Delete
Cancel

24.4.3 MLD Snooping-proxy VLAN Port Role Setting

Click the Port Role Setting link in the Advanced Application > Multicast > IPv6 Multicast >
MLD Snooping-proxy > VLAN screen to display the screen as shown. See
186 for more information on multicasting.
Chapter 24 Multicast
DESCRIPTION
Enter the amount of time (in miliseconds) between the MLD group-specific queries
sent by an upstream port when an MLD Done message is received. This value should
be exactly the same as what's configured in the connected multicast router.
This value is used to calculate the amount of time an MLD snooping membership
entry (learned only on the upstream port) can remain in the forwarding table after a
Done message is received.
When an MLD Done message is received, the Switch sets the entry's lifetime to be the
product of Last Member Query Interval and Robustness Variable.
Enter the amount of time (in miliseconds) between general query messages sent by
the downstream port.
Enter the maximum time (in miliseconds) that the Switch waits for a response to a
general query message sent by the downstream port.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields to your previous configuration.
Click Clear to reset the fields to the factory defaults.
This is the index number of the MLD snooping-proxy VLAN entry in the table. Click on
an index number to view more details or change the settings.
This field displays the ID number of the VLAN group.
Select an entry's check box to select a specific entry. Otherwise, select the check box
in the table heading row to select all entries.
Click Delete to remove the selected entry(ies) permanently.
Click Cancel to clear the check boxes.
GS2210 Series User's Guide
199
Section 24.1 on page