Lldp Configuration Org-Specific Tlv Setting - ZyXEL Communications GS2210 Series User Manual

The following table describes the labels in this screen.
Table 143 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
Port
*
Management
Address
Port Description
System
Capabilities
System
Description
System Name
Apply
Cancel

33.6.2 LLDP Configuration Org-specific TLV Setting

Use this screen to configure organization-specific TLV settings. Click Advanced Application >
LLDP > LLDP Configuration (Click Here) > Org-specific TLV Setting to display the screen as
shown next.
Chapter 33 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This displays the Switch's port number.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check box(es) to enable or disable the sending of Management Address TLVs
on the port(s).
Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
Select the check box(es) to enable or to disable the sending of System Capabilities TLVs
on the port(s).
Select the check box(es) to enable or to disable the sending of System Description TLVs
on the port(s).
Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide
301