ZyXEL Communications GS2210 Series User Manual page 246

source IPv6 address / prefix can only be in one static binding. If you try to create a static binding
with the same source IPv6 address / prefix as an existing static binding, the new static binding
replaces the original one. To open this screen, click Advanced Application > IP Source Guard >
IPv6 Static Binding Setup.
Figure 170 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
The following table describes the labels in this screen.
Table 112 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
LABEL DESCRIPTION
IPv6 Static
Binding
Source Address Enter the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address Enter the source MAC address in the binding. If this binding doesn't check this field,
select Any.
Note: You cannot choose Any for all three of MAC Address, VLAN and Port. You must fill
VLAN Enter the source VLAN ID in the binding. If this binding doesn't check this field, select
Any.
Port Specify the port(s) in the binding. If this binding has one port, select the first radio
button and enter the port number in the field to the right. If this binding applies to all
ports, select Any.
Add Click this to create the specified static binding or to update an existing one.
Cancel Click this to reset the values above based or if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each binding.
Source Address This field displays the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field
will not be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will
not be checked in the binding.
Chapter 26 IP Source Guard
in at least one.
GS2210 Series User's Guide
246