Mld Snooping-Proxy Filtering - ZyXEL Communications GS2210 Series User Manual

Table 86 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Port Role
Setting
LABEL
Port Role
Leave Mode
Leave Timeout
Fast Leave Timeout
Apply
Cancel

24.4.4 MLD Snooping-proxy Filtering

Use this screen to configure the Switch's MLD filtering settings. Click the Filtering link in the
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy screen to
display the screen as shown.
Chapter 24 Multicast
DESCRIPTION
A port on the Switch can be either a Downstream port or Upstream port in MLD. A
downstream port connects to MLD hosts and acts as a multicast router to send MLD
queries and listen to the MLD host's Report and Done messages. An upstream port
connects to a multicast router and works as a host to send Report or Done messages
when receiving queries from a multicast router.
Otherwise, select None if the port is not joining a multicast group or does not belong
to this VLAN.
Select the leave mode for the specified downstream port(s) in this VLAN.
This specifies whether the Switch removes an MLD snooping membership entry
(learned on a downstream port) immediately (Immediate) or wait for an MLD report
before the leave timeout (Normal) or fast leave timeout (Fast) when an MLD leave
message is received on this port from a host.
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to
update the forwarding table for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing
an MLD snooping membership entry (learned on a downstream port) when an MLD
Done message is received on this port from a host.
Enter the fast leave timeout (in milliseconds) for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing
an MLD snooping membership entry (learned on a downstream port) when an MLD
Done message is received on this port from a host.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to reset the fields to your previous configuration.
GS2210 Series User's Guide
201