ZyXEL Communications GS2210 Series User Manual page 207

Figure 145 Advanced Application > Multicast > MVR > Group Configuration
The following table describes the labels in this screen.
Table 90 Advanced Application > Multicast > MVR > Group Configuration
LABEL DESCRIPTION
Multicast VLAN ID Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down
list box.
Group Name Enter a descriptive name for identification purposes.
Start Address Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to
addresses.
End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Refer to
addresses.
Add Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
MVLAN This field displays the multicast VLAN ID.
Group Name This field displays the descriptive name for this setting.
Start Address This field displays the starting IP address of the multicast group.
End Address This field displays the ending IP address of the multicast group.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove, then click the Delete button. You can select the check box in the table
heading row to select all profiles.
To delete a rule(s) from a profile, select the rule(s) that you want to remove , then click
the Delete button.
Chapter 24 Multicast
IP Multicast Addresses on page 186
IP Multicast Addresses on page 186
GS2210 Series User's Guide
207
for more information on IP multicast
for more information on IP multicast