Anti-Arpscan Trust Host - ZyXEL Communications GS2210 Series User Manual

Figure 215 Advanced Application > Anti-Arpscan > Host Status
The following table describes the labels in this screen.
Table 149 Advanced Application > Anti-Arpscan > Host Status
LABEL
Clear Filtered
host:
Port List
Filtered host:
Index
Host IP
MAC
VLAN
Port
State

34.4 Anti-Arpscan Trust Host

Use this screen to create or remove trusted hosts identified by IP address and subnet mask. Anti-
arpscan is not performed on trusted hosts. To open this screen, click Advanced Application >
Anti-Arpscan > Trust Host.
Figure 216 Advanced Application > Anti-Arpscan > Trust Host
Chapter 34 Anti-Arpscan
DESCRIPTION
A filtered host is a blocked IP address.
Type a port number or a series of port numbers separated by commas and spaces, and
then click Clear to unblock all hosts connected to these ports.
This table lists information on blocked hosts.
This displays the index number of an IP address (a host) that has been blocked.
This displays the IP address of the blocked host.
This displays the MAC address of the blocked host.
This displays the VLAN ID that shows which VLAN the blocked host is in.
This displays the port number to which the blocked host is connected.
This shows Err-Disable if the ARP-request rate from this host is over the threshold.
Forwarding hosts are not displayed.
GS2210 Series User's Guide
311