Radius Server Setup - ZyXEL Communications GS2210 Series User Manual

25.3 RADIUS Server Setup

Use this screen to configure your RADIUS server settings. See
for more information on RADIUS servers and
utilized by the authentication features on the Switch. Click on the RADIUS Server Setup link in
the AAA screen to view the screen as shown.
Figure 152 Advanced Application > AAA > RADIUS Server Setup
The following table describes the labels in this screen.
Table 92 Advanced Application > AAA > RADIUS Server Setup
LABEL
Authentication
Server
Mode
Timeout
Index
Chapter 25 AAA
DESCRIPTION
Use this section to configure your RADIUS authentication settings.
This field is only valid if you configure multiple RADIUS servers.
Select index-priority and the Switch tries to authenticate with the first configured
RADIUS server, if the RADIUS server does not respond then the Switch tries to
authenticate with the second RADIUS server.
Select round-robin to alternate between the RADIUS servers that it sends authentication
requests to.
Specify the amount of time in seconds that the Switch waits for an authentication request
response from the RADIUS server.
If you are using index-priority for your authentication and you are using two RADIUS
servers then the timeout value is divided between the two RADIUS servers. For example, if
you set the timeout value to 30 seconds, then the Switch waits for a response from the
first RADIUS server for 15 seconds and then tries the second RADIUS server.
This is a read-only number representing a RADIUS server entry.
GS2210 Series User's Guide
213
RADIUS and TACACS+ on page 212
Section 25.6.2 on page 220 for RADIUS attributes