Removing Memory From Your Workstation - DEC Personal DECstation 5000 User Manual

Memory Modules
10.1 Adding Memory to Your Workstation
In this example, the workstation recognizes 4 megabytes of memory in slot
0, 4 megabytes in slot 1, and 8 megabytes in the base system module (B).
If the configuration display shows some amount of memory other than what
you've installed, turn to Chapter 13 for troubleshooting instructions or ask
your system manager or Digital service representative for help.

10.2 Removing Memory from Your Workstation

1. If the workstation software is running, shut it down: type shutdown -h
now and press Return.
2. Turn off the system unit by pressing the 0 on the on/off switch on the back
of the unit. Unplug the system unit power cord.
3. Open the system unit. (See Section 1.1.3.1.)
4. Locate the slot from which you want to remove the memory modules.
(Modules should always be removed in pairs.)
If a module is in front of the one you're removing, you must remove that
module first to gain access to the one you want to take out.
10–8 Memory Modules