Installing The Floppy Disk Drive In The System Unit - DEC Personal DECstation 5000 User Manual

Figure 9–4 Installing the Floppy Disk Drive in the System Unit
Tabs
Slot
WSMXS100
.
8. Lower the right side of the disk drive assembly so the hole in the mounting
bracket fits over the post on the base of the system unit. Press the drive
down firmly.
9. Slide the latch beside the post into the locked position.
10. Connect the floppy disk interface (FDI) cable to the FDI connector on the
base system module as shown in Figure 9–5.
11. Connect the internal drive power cable to the drive power connector on the
base system module. (Note: The internal drive power cable serves both the
floppy drive and the hard drive. If you've installed a hard drive, the power
cable will already be connected to the base system module.)
9.2 Installing a Floppy Disk Drive
Sliding latch
Post
Internal Storage Devices
Internal Storage Devices 9–5