Installing The Temperature Sensor Set - Buderus Logano GE615 Installation And Maintenance Instructions Manual

4
Installation

4.16.2 Installing the temperature sensor set

Both sensor wells have already been sealed in the flow
(Æ see section 4.7, page 20).
The sensors (controller sensor TRK, sensor STB and
Logamatic sensor FK or thermometer sensor) are inserted
into the sensor wells.
The STB sensor differs from the controller
sensor in that it has a side recess.
The sensors must be arranged as follows:
z Push controller sensor TRK out of the sensor holder by
pressing it gently.
z Feed controller sensor into sensor well R½ " and
secure with a screw.
z Feed both sensors, STB (high-limit safety cut-out) and
Logamatic FK, and the two sensor blanking pieces into
sensor well R¾ " and fix in place.
If using control panel 4212, the sensors must
be fed into the R¾ " sensor well. The R½ "
sensor well is not assigned if using this
control panel.
40
Fig 55 Temperature sensor set
Fig 56 Installing the temperature sensor set
Logano GE615 - We reserve the right to make any changes due to technical modifications.