Buderus Logano GE615 Installation And Maintenance Instructions Manual page 37

Before the remaining hood sections are put
in place, the control panel must be fitted, the
capillary tubes fed to the sensor wells and
the sensors placed in the sensor wells (Æ
see section 4.16.1, page 38 ff.).
z Screw the upper boiler rear panel to the rear of the
hood and the side panels.
z Screw the lower boiler rear panel with the cut-out for
the fill and drain connection down onto the side panels.
z Screw left/right front panel section to the cast lug on
the burner door, using four hexagon bolts for each.
z Hook burner door panel into the cut-outs in the front
panel.
Logano GE615 - We reserve the right to make any changes due to technical modifications.
Fig 50 Fitting the upper and lower boiler rear panels
1 Upper boiler rear pane
2 Lower boiler rear panel
Fig 51 Fitting the left and right front panel
1 Burner door panel
4
Installation
37