4.3.1
Base and boiler plinth
Place the boiler on a 50 – 100 mm high base (observe
wall clearances). The base must be flat and level. The
front edge of the boiler should be flush with the edge of
the base.
A sound-absorbing plinth is available as an
accessory. The boiler plinth prevents the
transmission of vibrations to the base.
If you are not using a boiler plinth (accessory), angled
steel sections (100 x 50 x 8 mm) or flat steel sections
(100 x 5 mm) must be put in place when installing the
base.
Number of
L1 (base)
sections
9
10
11
12
13
14
15
16
Tab. 9 Base dimensions for angled/flat steel sections
Logano GE615 - We reserve the right to make any changes due to technical modifications.
L2 (steel
section)
1670
1470
1840
1640
2010
1810
2180
1980
2350
2150
2520
2320
2690
2490
2860
2660
Fig 5
Base dimensions
4
Installation
11