Installing The Temperature Sensor Assembly - Buderus Logano GB125 BE Installation And Maintenance Instructions Manual

5
Installing the boiler
B Remove the top cover of the control panel.
– Unscrew the cover screws [1].
B Secure the control panel with self-tapping screws [2].
5.8.2

Installing the temperature sensor assembly

CAUTION: Risk of damage to system!
Capillary tubes can get damaged from
severe kinking or sharp burrs.
B Route capillary tubes carefully, avoiding
bending them excessively
B Feed the capillary tubes and the sensor lead [2]
through the cable entry in the front boiler top panel [1]
to the sensor well [3].
B Roll up surplus capillary tube and sensor lead length
and place on top of the thermal insulation.
B Feed the burner cable [4] through the cable entry in the
front boiler top panel [1] to the control panel.
B Connect the burner cable [4] to the control panel as
indicated by the terminal markings.
28
1
Fig. 25 Removing the cover
1 Cover screws
2 Self-tapping screws
Fig. 26 Routing and connecting cables
1 Cable entry in the front boiler cover
2 Capillary tube and sensor cable
3 Sensor well
4 Burner cable
Logano GB125 BE US/CA - Subject to technical modifications.
2
7 747 019 141-22.1RS