Other Errors - Toshiba e-STUDIO2330C Service Manual

26.4 Other errors

26.4.1 Equipment operation disabled after the installation of option(s)
Check if the optional board is installed properly.
26.4.2 Wireless LAN connection disabled
The connection state and settings of the Wireless LAN can be checked with [USER FUNCTIONS] →
[ADMIN] → [WIRELESS LAN] → [SETTING CHECK].
Confirm the settings with the administrator.
• "NIC INITIALIZING" does not disappear at the time of the power being turned ON and it disappears
after 6 minutes with the NIC initializing time-out. In this case, the connection to the Wireless LAN did
not succeed even though "NIC INITIALIZING" disappears.
• The connection to the Wireless LAN cannot be made if the Access Point to be connected is not
found or security settings are not correct.
26.4.3 "Start page" printing disabled after the installation of the EFI
Printer Board (GA-1211, optional)
When the firmware of the equipment or the system software of the EFI printer board is updated,
perform "Initialization of NIC information (08-693)" and "Default setting of the EFI printer board (08-
700)" if "Start page" is not printed out after a specified period of time. (In case of the equipment's
firmware, wait approx. 3 minutes and in case of the EFI printer board's system software, wait approx.
10 minutes.)
1. Turn OFF the power of the equipment.
2. Confirm that the power of the EFI printer board is also turned OFF. (The 7-Segment LED of the
EFI printer board goes off.)
3. Turn ON the power of the equipment while pressing digital keys [0] and [8] simultaneously to
enter the Setting Mode (08).
4. Confirm that the power of the EFI printer board is also turned ON. (The 7-Segment LED of the
EFI printer board is lit.)
5. Key in [693] and press the [START] button (Initialization of NIC information).
6. Key in [700] and press the [START] button (Default setting of the EFI printer board).
7. Turn OFF the power of the equipment.
8. Confirm that the power of the EFI printer board is also turned OFF.
9. Turn ON the power of the equipment.
26.4.4 Abnormality Related to Imaging Acceleration Board (GE-1170,
optional)
When an abnormality related to the Imaging Acceleration Board (GE-1170, optional) occurs, the
specified icon on the touch panel is displayed in gray.
Perform code 08-9966 (Imaging Acceleration Board operation check) to check the status of the board.
If the abnormality is derived from the hardware, replace the board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
26 - 121
26