Skew (Slantwise Copying) - Toshiba e-STUDIO2330C Service Manual

26.5.13 Skew (slantwise copying)

Cause/Section Step
Drawer/LCF 1 Is the drawer or LCF properly installed?
2 Is too much paper loaded in the drawer or
LCF?
3 Is the paper corner folded?
4 Are the drawer or LCF side guides
properly set?
Paper feed roller 5 Is the surface of paper feed roller dirty?
Rollers 6 Is each roller improperly fixed to the
shaft?
Aligning amount 7 Is the aligning amount proper?
Registration 8 Is the registration roller spring removed?
roller
Pre-registration 9 Is the pre-registration guide improperly
guide installed?
2nd transfer 10 Is the 2nd transfer front guide installed
front guide properly?
RADF 11 Is the RADF installed and adjusted
properly?
Transfer unit 12 Is the transfer belt unit installed properly?
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 26-12
Check items
26 - 139
Measures
Reinstall the drawer or LCF properly.
Reduce paper to 550 sheets or less.
(2500 sheets or less/stack for LCF)
Change the paper direction and reinsert it.
Adjust the side guides.
Clean the roller surface with alcohol, or
replace the roller.
Check E-rings, pins and clips.
Increase the aligning amount.
Mount the spring correctly. Clean the
roller if it is dirty.
Correct it.
Correct it.
Reinstall and readjust it.
Correct it.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
26