Toshiba e-STUDIO2330C Service Manual page 1049

[CC31] Transport motor abnormality
* You receive a [CC31] error when the [ED12] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the stack transport roller -1 and -2 are rotated?
YES
 Fix the mechanism.
NO
Is the harness between the transport motor (M2) and the finisher control PC board (CN5)
disconnected or open circuited?
YES
l •

•
NO
1. Replace the transport motor (M2).
2. Replace the finisher control PC board.
[CC40] Swing motor abnormality
MJ-1030
Is the swing unit home position sensor (PI35) normal?
 NO 
Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the swing motor (M36) correct?
 NO 
Correct the wiring.
YES
Is the swing mechanism normal?
 NO 
Fix the mechanism.
YES
1. Replace the swing motor.
2. Replace the finisher controller PC board.
[CC41] Paper holder cam home position abnormality
MJ-1101
Is there any mechanical problem when the paper holder cam is rotated?
YES
 Fix the mechanism.
NO
Is the harness between the paper holder home position sensor (S6) and the finisher control PC
board (CN17) disconnected or open circuited?
YES
l •

•
NO
1. Replace the paper holder home position sensor (S6).
2. Replace the finisher control PC board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Reconnect the connector securely.
Replace the harness.
Reconnect the connector securely.
Replace the harness.
26 - 79
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
26