Toshiba e-STUDIO2330C Service Manual page 1231

REVISION RECORD
Ver.05
Page
7-9 The behavior inside the exposure lamp has been corrected.
Correction has been made in the illustration.
9-17 Correction has been made in the illustration.
13-25 The disassembly procedure has been changed. (The coupling has been added.)
14-11 The content of step 2 has been changed.
The illustration in Fig. 14-5 has been changed.
16-19 Note for installing the pressure roller cover has been added.
The illustration in Fig. 16-14 has been added.
19-19 "Pad" for G4 has been corrected to "Felt".
19-21 "G5: Recovery blade" has been corrected to "G4: Felt".
"G6: Drum thermistor" has been corrected to "G5: Recovery blade".
20-6 A note regarding updating with the USB media has been added.
20-10 The contents of Notes have been changed.
20-19 The contents of Notes have been changed.
21-18 A note has been added to "21.2.3 Precautions and procedures when replacing the HDD".
21-24 A note has been added to "21.2.6 Precautions and procedure when replacing the SRAM
board (for the SYS board)".
21-28 The description of 05 code for HVT label has been changed.
21-30 "21.2.8 Firmware confirmation after the PC board/HDD replacement" has been added.
21-31 "21.3 Precautions for Disposal of the HDD and PC boards" has been changed to "21.3 Pre-
cautions for Installation of GP-1070 and Disposal of HDD/Board".
22-3 The procedure has been corrected.
The contents of Note have been changed.
22-6 The procedure has been corrected.
The contents of Note have been changed.
23-16 A version list has been added to the table in "23.4 List printing".
23-25 A version list has been added.
26-33 E090 troubleshooting has been changed. (An item for the page memory has been added.)
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Ver.05 <2009.1.27>
Contents
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
1
REVISION RECORD