Toshiba e-STUDIO2330C Service Manual page 1192

(5) Press [Button1] and [Button2] as described in the following table to set the B4-size recycled
paper mode. Press [Button1] and [Button2] on the control panel as below to set the B4-size
recycled paper mode.
Note:
Be sure to press [Button1] and [Button2] the correct number of times.
Press [Button1] and [Button2] simultaneously to cancel the operation.
B4-size recycled paper mode
Step Buttons
1 Button1
2 Button2
3 Button1
4 Button2
Note:
To change settings from the B4-size recycled paper mode to the normal mode, perform steps (1)
through (4), and then press [Button1] and [Button2] on the control panel as shown below to set
the normal mode.
Normal mode
Step Buttons
1 Button1
2 Button2
3 Button1
4 Button2
(6) When the settings are stored normally, [LED1] on the control panel is lit. [LED1] blinks, if an error
occurs. In this case, turn the power OFF and make the settings again from step (4).
(7) Turn OFF the power of the equipment.
(8) Turn OFF all bits of the SW1 on the Finisher control board.
(9) Install the board access cover.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
SETTING / ADJUSTMENT OF OPTION
LED3 LED2
Button1
Fig. 28-73
Number of pressing
1
1
8
1
Number of pressing
1
1
6
1
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
28 - 30
LED1
Button2
Remarks
Confirms the input value
Confirms the input value
Remarks
Confirms the input value
Confirms the input value