Toshiba e-STUDIO2330C Service Manual page 831

Classific
Code
ation
6962-0 Counter Accelerating
mode counter:
2nd transfer
roller
6962-1
6962-2
6962-3
Note:
In this equipment, a toner image is formed on the transfer belt prior to a paper feeding.
When the feeding retry occurs and the transport timing is delayed, the toner image on the
transfer belt is cleaned off without the 2nd transfer since the paper cannot be reached for the 2nd
transfer process.
After that, the toner image formation is retried while the paper is waited.
In this case, the toner for this image formation is consumed wastefully since the toner image on
the transfer belt is already cleaned off, even though the printing is normally completed.
Therefore, note that the excessive toner will be consumed consequently when the upper limit
value of feeding retry counter is set larger or set as "0" (no limit).
The toner is also consumed wastefully when the paper misfeeding occurs. Replace the roller at
earlier timing if the paper misfeedings have occurred frequently.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Setting mode (08)
Functi <Accept
Items
on
Present ALL
number of <8 digits>
output
pages
Number of ALL
output <8 digits>
pages at
the last
replaceme
nt
Present ALL
drive <8 digits>
counts
Drive ALL
counts at <8 digits>
the last
replaceme
nt
25 - 95
Default
RAM Contents
able
value>
0 M Present number of
output pages:
Displays the
accumulated number of
sheets that have been
0 M
printed at present. Only
"0" is acceptable. When
"0" is entered, the
counter is reset.
Number of output
0 M
pages at the last
replacement:
Displays the total
0 M
number of output pages
at the last replacement.
"0" is displayed if no
replacement was
performed.
Present drive counts:
Displays the
accumulated driving
time at present. Only
"0" is acceptable. When
"0" is entered, the
counter is reset.
(1 count = 4 seconds)
Drive counts at the last
replacement:
Displays the total
driving time at the last
replacement. "0" is
displayed if no
replacement was
performed.
(1 count = 4 seconds)
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
Proce
dure
4
4
4
4
SETTING MODE (08)
25