Table of Contents
Advertisement
Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (07/10)
The two Giga port has been offered as
GBPM-2OTX (fiber or RJ-45), whereas the
single Gigabit module comes in flavor of
G+4(10/100 RJ-45 ports) or G+2 (100Mb
fiber ports) as shown below in the above
figure.
Each port has an Activity (ACT)
LED indicating packets being received and a
link (LK) LED indicating proper
connectivity with the remote device when lit.
5.2.13
6KM-BLNK
The 6KM-BLNK is a blank face
plate or cover plate that must be installed in
any empty 6K32F Series PM slot to
maintain proper cooling air flow, safety, etc.
Four screws hold the 6KM-BLNK in place.
6.0
TROUBLESHOOTING
All Magnum Ethernet products are designed to provide reliability and
consistently high performance in all network environments. The installation of a
Magnum 6K32F Series Switch is a straight-forward procedure (see INSTALLATION,
Section 3.0); the operation is also straight-forward and is discussed in Section 4.
Should problems develop during installation or operation, this section is
intended to help locate, identify and correct these types of problems. Please follow the
suggestions listed below prior to contacting your supplier. However, if you are unsure of
the procedures described in this section or if the Magnum 6K32F Series Switch is not
performing as expected, do not attempt to repair the unit; instead contact your supplier
for assistance or contact GarrettCom Customer Support.
www GarrettCom com
.
.
60
Advertisement
Table of Contents
