Table of Contents
Advertisement
Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (07/10)
The LEDs on 6KP8-RJ45- PoE modules are slightly different compared to
regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the
PoE LED is ON when connected properly to an 803.af compliant PD device on that port.
When non-PoE devices are connected, the PoE LED is OFF. PoE does not affect
operation of Ethernet data traffic.
LINK and ACTIVITY LEDS are combined on the PoE modules into one LED
that is marked as LINK/ACT, as shown in the diagram.
PoE LEDs Summary
•
For PoE devices, each RJ-45 PoE port supports only 802.3af complaint
devices. The PoE LED is ON when the attached PD is drawing power from the
port.
•
For non-PoE devices connected, the PoE port will act as a normal RJ-45 port
and the PoE LED is OFF. No power is being sent out from the port.
•
The PoE ports in Magnum 6K's with 48VDC power input act as a pass-
through, so the 48VDC power source must be strong enough to provide power
to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to
15 watts per PoE port).
•
In the case where the 48VDC power in not internally connected and no power
is coming to the PoE ports for some reason, all the PoE port LEDs are ON
simultaneously to indicate a trouble condition. The ports will still operate
properly for data traffic.
5.2.10a PoE(Power Inside), PI6KP8-45RJ (MDIX),
10/100Mb 8-port
The PoE RJ-45 ports act similar to regular RJ-45 ports, except they have the
capability of providing power on each port to power up the PD devices, per the
IEEE802.3af PoE standard. Only 4 x RJ-45 (10/100) ports max. support POE (Power
Inside) option in one 6K-unit. In this Fig. the top 4-RJ45 ports are enhanced with the
POE option whereas the bottom 4- RJ-45 ports are normal MDIX ports. The 4-RJ45 POE
modules are also available with mix –n-match fiber modules. Please check the ordering
information Sec.1.2. for all the various PI6K PoE module options.
The LEDs on 6KP8-RJ45- PoE modules are slightly different compared to
regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the
PoE LED is ON when connected properly to an 803.af compliant PD device on that port.
When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data
traffic is not affected by PoE.
www GarrettCom com
.
.
56
Advertisement
Table of Contents
