Table of Contents
Advertisement
Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (07/10)
LINK and ACTIVITY LEDS are combined on the PoE modules into one LED
that is marked as LINK/ACT, as shown in the diagram.
PoE LEDs Summary
•
For PoE devices, each RJ-45 PoE port supports only 802.3af complaint
devices. The PoE LED is ON when the attached PD is drawing power from the
port.
•
For non-PoE devices connected, the PoE port will act as a normal RJ-45 port
and the PoE LED is OFF. No power is being sent out from the port.
•
The PoE ports in Magnum 6K's with 48VDC power input act as a pass-
through, so the 48VDC power source must be strong enough to provide power
to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to
15 watts per PoE port).
•
In the case where the 48VDC power in not internally connected and no power
is coming to the PoE ports for some reason, all the PoE port LEDs are ON
simultaneously to indicate a trouble condition. The ports will still operate
properly for data traffic.
5.2.11
6KP8-45-2MT, 6@ 10/100Mbps RJ-45 and 2@100Mb multi-mode
FX , MTRJ Small-Form-Factor
The Magnum 6KP8-
45-2MT eight port Module is a
combo module with copper and
fiber (Small Form Factor)
MTRJ type ports. The small
sizes of MTRJ connectors give
an advantage of placing more
fiber ports on one module. The
6KP8-45-2MT is equipped
with six 10/100 RJ-45 ports
and two 100Mb MTRJ fiber
ports. When installed in a Magnum 6K32F Series Switch, it supports the standard
distances as mentioned on 5.2.3. and the LEDs also act similarly.
www GarrettCom com
.
.
57
Advertisement
Table of Contents
