DFI EC200 User Manual page 63

SIO F81216
This section configures the system I/O chip parameters.
InsydeH20 Setup Utility
Advanced
SIO F81216
Serial Port 7 <Enable>
Base I/O Address <240>
Interrupt <IRQ3>
RS485 Auto Flow Control <Disable>
Serial Port 8 <Enable>
Base I/O Address <248>
Interrupt <IRQ4>
RS485 Auto Flow Control <Disable>
Serial Port 9 <Enable>
Base I/O Address <250>
Interrupt <IRQ5>
RS485 Auto Flow Control <Disable>
Serial Port 10 <Enable>
Base I/O Address <258>
Interrupt <IRQ7>
RS485 Auto Flow Control <Disable>
F1 Help ↑↓ Select Item F5/F6
Esc Exit ←→  Select Menu Enter
Serial Port 7 to Serial Port 10
Configure the options to use the serial port.
Disable No configuration
Enable
User confi guration
Auto
EFI/OS chooses confi guration
RS485 Auto Flow Control
Enable or disable the RS485 auto flow control.
Chapter 7 BIOS Setup
Rev. 5.0
Confi gure Serial port using
options: [Disable] No Con-
figuration [Enable] User
Confi guration [Auto] EFI/
OS chooses confi guration.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 7
Security
Main Advanced
TPM 1.2 Status
TPM Operation
Supervisor Password
Set Supervisor Password
F1 Help ↑↓ Select Item
Esc Exit ←→ Select Menu

TPM Operation
Enable or disable the TPM function. This option will automatically return to
No-Operation.
Set Supervisor Password
Set the supervisor's password and the length of the password must be greater than
one character.
63
InsydeH20 Setup Utility
Security Power Boot Exit
Enable/Disable TPM Func-
Enable and Active
tion. This option will au-
<No operation>
tomatically return to No-
Not installed
Operation.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Rev. 5.0
www.dfi .com