Installing A Sodimm Module - DFI EC200 User Manual

Installing a SODIMM Module

1. The SODIMM socket is located on the system board.
SODIMM socket
2. Note the key on the socket. The key ensures the module can be plugged into the socket in
one direction only.
Chapter 3 Installing the Devices
Chapter 3
3. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees angle. Apply firm even pressure to each end of the module until it slips down into
the socket. The contact fingers on the edge of the module will almost completely disappear
inside the socket.
4. Push the module down until the clips at each end of the socket lock into position. You will
hear a distinctive "click", indicating that the module is correctly locked into position.
Important:
When installing one DDR3L SODIMM only, make sure to install it into the SODIMM 1
socket.
18
SODIMM Module
Clip
www.dfi .com