DFI EC200 User Manual page 61

SIO NUVOTON6106D
This section configures the system super I/O chip parameters.
InsydeH20 Setup Utility
Advanced
SIO NUVOTON6106D
 Smart Fan Control

<Enable>
Serial Port 1
Base I/O Address <3F8>
<IRQ10>
Interrupt
<Disable>
RS485 Auto Flow Control
<Enable>
Serial Port 2
Base I/O Address <2F8>
<IRQ11>
Interrupt
<Disable>
RS485 Auto Flow Control
<Enable>
Serial Port 3
<3E8>
Base I/O Address
Interrupt <IRQ10>
<Disable>
RS485 Auto Flow Control
<Enable>
Serial Port 4
<2E8>
Base I/O Address
Interrupt <IRQ11>
<Disable>
RS485 Auto Flow Control
<Enable>
Serial Port 5
<338>
Base I/O Address
Interrupt <IRQ10>
<Disable>
RS485 Auto Flow Control
<Enable>
Serial Port 6
<228>
Base I/O Address
<IRQ11>
Interrupt
RS485 Auto Flow Control <Disable>
<Enable>
LPT Port A
<378>
Base I/O Address
Interrupt <IRQ10>
<Enable>
WDT
<SECOND>
WDT Mode
COUNTER [0]
<Disable>
Case Open
 Hardware Monitor

F1 Help ↑↓ Select Item F5/F6
Esc Exit ←→  Select Menu Enter
Chapter 7 BIOS Setup
Rev. 5.0
Enable/Disable Smart Fan.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 7
Serial Port 1 to Serial Port 6
Configure the options to use the serial port.
Disable No configuration
Enable
User confi guration
Auto
EFI/OS chooses confi guration
LPT Port A
Configure the options to use the LPT port.
Disable No configuration
Enable User confi guration
Auto EFI/OS chooses configuration
RS485 Auto Flow Control
Enable or disable the RS485 auto flow control.
WDT Mode
Select the count mode: minute or second.
Counter
Enter the value for the counter. The time-out counter ranges from 1 to 255 minutes in
the minute mode and from 1 to 255 seconds in the second mode.
Case Open
Enable or disable the case open.
Note:
To make the RS485 auto flow control function work on COM 1 to COM 4, please set
either 8 data bits + 1 stop bit or one of the following settings:
(1) 8 data bits + 1 parity bit + 1 stop bit
(2) 8 data bits + 1 parity bit + 2 stop bits
(3) 8 data bits + 2 stop bits
61
www.dfi .com