Page 2
1. Before installing any internal devices, please reverse the bottom of the case to the top. 2. If you need to install or replace the CPU and 2nd memory, please also remove the three screws at each side of the box. Quick Installation Guide | ES220-CS Quick Installation Guide |...
Page 3
3. After the screws was removed in last two steps, tilt up the case carefully. 4. After the upper case was removed, 2.5" SDD slots / M.2 slots appears. Quick Installation Guide | Quick Installation Guide | ES220-CS...
Page 4
5. There are two M.2 slots and an InnoAGE HDR1 pinout on the board. 6. To install or replace the SO_DIMM2, remove the 4 screw around the 2.5" slots first, and tilt up the slot. Quick Installation Guide | ES220-CS Quick Installation Guide |...
Page 5
7. To install or replace the SO_DIMM2, remove the 4 screw around the 2.5" slots first, and tilt up the slot. 8. Then you can install the memory on the SO_DIMM2 slot. Quick Installation Guide | Quick Installation Guide | ES220-CS...
Page 6
9. Before rotate the board to the next side, remove the side case first. 10. Rotate the case, loosen the four screws marked in red, and tilt up the plate. Quick Installation Guide | ES220-CS Quick Installation Guide | Quick Installation Guide |...
Page 7
11. After that plate was tilted up, remove each screw marked in red located in each corner. 12. Rotate the case again and reverse the board, then you can install other components including CPU on the board. Quick Installation Guide | ES220-CS ver.A_-_6-1921_9-9...