9~36V Dc-In - DFI EC200 User Manual

The rear panel I/O ports consist of the followings:
EC220/EC221 - BTA881
• 1 DC-in power jack: 3-pole terminal block
• 1 Speaker-out: 2W 3.5mm audio jack
• 1 DVI (DVI-D signal)
• 1 VGA: DB-15 D-sub
• 2 RJ45 LAN ports
• 2 RS232 Serial COM ports
• 4 RS232/422/485 Serial COM ports
• 1 USB 3.0 (Type A) port
• 3 USB 2.0 (Type A) ports
• 1 8-bit GPIO: 9-pole terminal block
• 1 Reset button
• 1 Power LED
• 1 HDD LED
• 1 Alert LED
EC220/EC221 - BTAG60
• 1 DC-in power jack: 3-pole terminal block
• 1 Speaker-out: 2W 3.5mm audio jack
• 1 VGA: DB-15 D-sub
• 2 RJ45 LAN ports
• 2 RS232 Serial COM ports
• 4 RS232/422/485 Serial COM ports
• 1 USB 3.0 (Type A) port
• 1 USB 2.0 (Type A) port
• 2 8-bit GPIO: 9-pole terminal block
• 1 Reset button
• 1 Power LED
• 1 HDD LED
• 1 Alert LED
EC220/EC221 - BT6060
• 1 DC-in power jack: 3-pole terminal block
• 1 Speaker-out: 2W 3.5mm audio jack
• 1 VGA: DB-15 D-sub
• 2 RJ45 LAN ports
• 2 RS232 Serial COM ports
• 1 USB 3.0 (Type A) port
• 1 USB 2.0 (Type A) port
• 1 Reset button
• 1 Power LED
• 1 HDD LED
• 1 Alert LED
Chapter 5 Ports and Connectors
Chapter 5

9~36V DC-in

This jack provides maximum of 60W power and is considered a low power solution. Connect
a DC power cord to this jack. Use a power adapter within 9~36V DC output voltage. Using a
voltage out of the range 9~36V may fail to boot the system or cause damage to the system
board.
39
DC-in
www.dfi .com