I/O Connectors; Serial Ata Connectors; Serial Ata Power Connectors; Front Panel Connector - DFI EC200 User Manual

I/O Connectors

Serial ATA Connectors

Serial ATA Power Connectors

GND
TXP
1
TXN
GND
RXN
RXP
7
GND
SATA Power 1
SATA 1
GND
TXP
1
TXN
SATA Power 0
GND
RXN
RXP
7
GND
SATA 0
4
SATA 2.0 3Gb/s
+5V
Ground
Ground
+12V
1
Features
• 2 Serial ATA 2.0 ports with data transfer rate up to 3Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connector is used to connect the Serial ATA device. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
The SATA power connector supplies power to the SATA drive. Connect one end of the provided
power cable to the SATA power connector and the other end to your storage device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu ("SATA Configuration" submenu) of the
BIOS. Refer to chapter 7 for more information.
Note:
SATA port 0 provides adequate space for SATA DOM.
Chapter 5 Ports and Connectors
Chapter 5

Front Panel Connector

1 2
PWR-LED
HDD-LED
PWR-BTN
RESET-SW
11 12
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET-SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
Pin Pin Assignment
3 HDD Power
HDD-LED
5 Signal
7 Ground
RESET-SW 9 RST Signal
11 N.C.
44
Front
Panel
Pin Pin Assignment
2 LED Power
PWR-LED 4 LED Power
6 Signal
8 Ground
PWR-BTN
10 Signal
www.dfi .com